 |
 |
|
EFFECTIVE RUST CONTROL, WITHOUT TIME-CONSUMING PREPERATION!! |
noverox is a product of SWITZERLAND - Quality for professionals! |
|
 |
||
~ noverox reacts directly with rust - no need to grind back to bright metal. |
||
~ Simple and clean to use: apply straight onto rusted surfaces. |
||
~ Its long-term effectiveness has been tested and verified by the Technical Supervisory Association, The Federal Institute for Material Testing (BAM) Berlin, The Association of German Gas and Water Specialists (DVGW) Karlsruhe and meets the KTW recommendation for vessels and fittings, and by the Bureau Veritas PARIS. |
||
~ NON-polluting: contains NO LEAD, ZINC Chromate or mineral acids. |
 |
 |
 |
~ Home and Yard use - pipes, fences, iron gates, metal balcony railings, door hinges, garden furniture, outdoor lamps, oil or gas heating tanks, garden tools, garden equipment. ~ Car Exterior - body, frame, suspension components, rims, under hood, linkages, drive shaft, floor. ~ Car Interior - Under the carpets, door frames, trunk area, spare wheel compartment, battery support, seat brackets, dash brackets. |
|
1 - Uncover rusted areas using a wire brush or course sand paper. |
 |
|
2 - Sponge with clean water to wash away possible salt deposits and degrease if necessary. |
||
3 - First coat of noverox applied directly on the rusted surfaces. noverox can be applied on damp surfaces. Brush just beyond the edges of rust to seal the rust spot hermetically (noverox WILL NOT HARM PAINT). |
||
4 - approximately one hour after the first coat, apply second coat across the direction of the first coat for complete coverage. A stable black metal-organic layer will form with in 24 hours, penetrating into all the rusted areas of the metal. |
||
 |
5 - This spot will NEVER rust again thanks to the black protective coat of noverox. In 24 hours or more you can apply body filler or paint directly on the black layer. At this stage here, the rust is protected and can be used as a final coat if desired. |
|
6 - Rough and un-even spots can be smoothed out using body fillers. POLYESTER fillers are NOT suitable. |
||
7 - SANDING AND FINISHING - Sand the area carefully, NOT to go through to shiny metal before paint. |
||
8 - Start with a very thin coat of paint and let it tack up. Then continue with final coat. noverox can be directly painted on as it acts like a base primer. |
||
- Highgravity Productions is a noverox distributor for North America - |
||